Peugeot 308 Key Fob Replacement
Peugeot's 308 might be catching on a little but it's still appealing. It's not the most luxurious vehicle in its class, but it is an enjoyable and relaxing driving experience.
We are often asked at Coded Car Keys to replace peugeot key fobs. If the issue is intermittent or constant the following tips will help.
Water Damage
If you accidentally drop your key fob into the puddle, or it gets wet while kayaking, canoeing, rafting or canyoning it is likely to be damaged by water. Keep your key fob in a dry container whenever you go outdoors or do activities that expose it to excessive amounts water.
It's also crucial to ensure sure that the fob is completely dried out before you open it up and then use it again. If you notice any smells from the fob (such as industrial fluid or windshield washer fluid) This is a further indicator that it is submerged.
A wet circuit may cause the battery's charge to be drained or even explode. If you're able to fish your key fob 308 out of whatever body of water it got stuck in, flip the button side down and shake out as much water as possible before opening the case. After opening it, take off the battery and clean the circuit board with the help of a cotton swab that has been dipped in 90 percent isopropyl alcohol.
Other reasons why your Peugeot 308 remote keyless entry system might not function include the battery of your coin is dead, receiver module issues signal interference, an electronic chip malfunctioning. If none of the above are the reason you can restart the system by removing the 12 Volt battery from the car for 15 mins.
Dead Coin Battery
Peugeot cars are equipped with a remote-start system that allows the driver to start the car from a distance, warming up or cooling down the vehicle prior to getting in. This feature is extremely useful, especially during cold winter months. The remote start system can not function due to a variety of reasons, such as the dead battery in the coin-battery.
A coin-shaped battery that is found inside the key fob has a life span of two to four years, based on how frequently it is used and where it's purchased. The date of use is printed on the packaging or mentioned in the user manual.
If the key fob is no longer working after exposure to clean tapwater, remove the battery and clean the electronic chip with an absorbent paper towel that has been soaked in isopropyl ethanol. Then, dry the chip thoroughly before replacing it. If the key fob was exposed to soapy or salty water, it could have caused the chip to be damaged. You'll need to replace it.
If you're not sure whether the battery is in good condition You can test its voltage using a multimeter attached to both the minus and plus terminals. If the voltage is lower than 12-13 volts then you need to replace the battery. If you want to, you can attempt to reset the onboard computer by disconnecting the 12 volt battery for a short period of time, and reconnecting it in reverse order (positive cable first and then negative). The engine should start.
Faulty Receiver Module
If you're not getting the "Key Detected" message on your dashboard, then it's possible the receiver module has been afflicted with a fault. It's the component that transmits an alert when the key fob goes off. It also acts as an alarm, and stops the vehicle from starting without the correct key.
This could be caused by a number of causes, such as water damage or simply the aging process. If your Peugeot 308 key fob has been exposed dirty tap water, for instance the electronic chip inside the device will be damaged. In this scenario it is necessary to take the device apart and thoroughly clean it with isopropyl alcohol or an electronic cleaner. When the battery is dry then you can try again.
If the issue is not resolved, it is recommended to visit an area Peugeot expert or locksmith. They'll be able employ a diagnostic tool identify the problem and repair it for you.
Losing your Peugeot car keys can be an extremely stressful experience. A reputable auto locksmith will be able to solve the issue in a matter of minutes. They can program your car and cut a brand new, functioning key for you. Click here to find a locksmith near you.
Faulty Electronic Chip
The electronic chip inside the Peugeot 308 key fob is a critical function in the remote control system. If it becomes damaged, your car might not start or you may get a message saying "anti-theft active". If this occurs, the only way to fix the problem is to purchase a new key. Auto locksmiths with experience are able to offer the fastest possible time.
The chip inside your Peugeot 308's key fob may fail due to various reasons, including water damage, sweat or dirt. If your Peugeot 308 key fob has been exposed to soapy water, you must clean it right away. You can make use of a towel and isopropyl alcohol for cleaning the electronic component. After that, you should let the battery completely dry.
Sometimes keys may cease to function due to radio interference. This is usually caused by other devices operate on the same frequency as your Peugeot keyfob. It could also be caused by weather conditions or objects in the vicinity. If you encounter this issue it is advised to visit a Peugeot dealership.
The Peugeot Key Fob 207/308 is fragile and requires special care. It is crucial not to throw or drop the key fob. If you lose it, try to locate it as quickly as possible. You can reset all on-board computers by disconnecting the 12 volt battery for a few minutes. Unplug the negative cable prior to the positive.